Home > Vogelsang Products > Tension Bushings > Specification Chart 3/16" Nominal Wall Thickness
Specification Chart 3/16" Nominal Wall Thickness

1 2 3 4 5 6 7 8 9 10 11 12
Nominal
O.D.		 Nominal
I.D.
(Shaft/Pin size)		 Lengths Recommended Hole Size Outside Diam.
Before
Insertion		 Inside Diam.
After
Insertion		 Length of
Chamfer
"A"(O.D.)		 Allowable
Hole
Tolerance
Min Max Min Max Min Max* Min Max
1 1/8 3/4 3/4 - 2 1.1250 1.1263 1.145 1.165 .753 .757 .080 .120 +.004
- .005
1 3/8 1 3/4 - 2 1.3750 1.3765 1.395 1.415 1.003 1.007 .080 .120 +.004
- .005
1 1/2 1 1/8 3/4 - 2 1.5000 1.5015 1.520 1.540 1.128 1.132 .080 .120 +.004
- .005
1 5/8 1 1/4 3/4 - 2 1.6250 1.6265 1.645 1.665 1.253 1.257 .080 .120 +.004
- .005
1 3/4 1 3/8 3/4 - 2 1.7500 1.7515 1.770 1.790 1.378 1.382 .080 .120 +.004
- .005
1 7/8 1 1/2 3/4 - 2 1.8750 1.8765 1.895 1.915 1.503 1.507 .080 .120 +.004
- .005
2 1 5/8 1 - 2 1/2 2.0000 2.0015 2.040 2.020 1.629 1.637 .080 .120 +.004
- .005
2 3/8 2 3/4 - 2 2.3750 2.3768 2.406 2.431 2.004 2.012 .100 .150 +.006
- .005

NOTES:

The recommended hole sizes shown in columns 4 & 5 above are required to maintain the inside diameters after the bushings are inserted as shown in columns 8 & 9. If the clearance between the bushings and the pin is not critical, greater hole tolerances are allowable and will still insure proper seating of the bushings. These tolerances are indicated in column 12 of the table. Internal chamfer available upon request.

*For length above 1 1/2 inches, the max ID after insertion is as shown +.003
Home | Corporate Profile | Certifications & Awards | Vogelsang Products | Product Usage Guides
Request Quote| FAQs | Contact Information

E-mail: vogelsang@rollpin.com | Phone: (732) 364-4422 | (800) 526-2376 | Fax: (732) 364-8111

© Vogelsang Corporation
"ROLLPIN" is a registered trademark of Vogelsang Corporation.